Commercial Lighting Products

RTS Series

    RTS Series Diagram - WLS Lighting

    Specifications

    POLE SHAFT – Pole shaft is electro-welded ASTM-A595 Grade A steel tubing with a minimum yield strength of 55,000 psi. On Tenon Mount steel poles, tenon is 2-3/8” O.D. high-strength pipe. Tenon is 4-3/4“ in length.

    HAND HOLE – Standard hand-hole location is 12” above pole base. Hand-hole size is 4“ X 6” and reinforced.

    BASE – Pole base is ASTM-A36 hot-rolled steel plate with a minimum yield strength of 36,000 psi. Two-piece square base cover is optional.

    ANCHOR BOLTS – Poles are furnished with anchor bolts featuring zinc-plated double nuts and washers. Galvanized anchor bolts are optional. Anchor bolts conform to ASTM-A36 with a minimum yield strength of 36,000 psi.

    GROUND LUGS – Ground lug is standard.

    DUPLEX RECEPTACLE – Pole preparation for weatherproof duplex receptacle is optional.

    GROUND FAULT CIRCUIT INTERRUPTER – Pole preparation for ground fault circuit interrupter is optional.

    FINISHES – Each steel pole is finished with WLS DuraGrip® baked-on polyester powder coat finishing process to give the pole an exceptionally attractive appearance. The process electrostatically applies and thermally fuses a polyester powder to the pole. This unique protection process provides an extremely smooth and uniform finish which withstands extreme weather changes without cracking or peeling. DuraGrip® finish features a five-year limited warranty. Standard finish colors available for poles are bronze, black, platinum plus, buff, white, satin verde green, metallic silver, and graphite. Optional DuraGrip® Plus features added protection with a 3.0 to 5.0 mil thickness of polyester-powder coat finish plus an inner coating. This specially designed inner coating is a thermal plastic hydrocarbon resin applied to the inside of the pole to seal and protect against atmospheric and corrosive matter. DuraGrip® Plus finish features a seven-year limited warranty.

    DETERMINING THE LUMINAIRE / POLE COMBINATION FOR YOUR APPLICATION

    • Select luminaire from Luminaire Ordering Information.
    • Select bracket configuration.
    • Refer to Luminaire EPA chart to determine EPA value.
    • Select height of pole.
    • Select MPH to match the wind speed in the application area. (Windspeed Map located in appendix)
    • Confirm the pole EPA that is equal to or exceeds the luminaire / bracket EPA as was previously determined.
    RTS Series Anchor Bolt and Baseplate - WLS Lighting

     


     

    Footnotes

    1. Pole heights will have +/- 1/2” tolerance
    2. Pole preparation only. Receptacle sold separately.

    EPA INFORMATION:All WLS Lighting Systems’ poles are guaranteed to meet the EPA requirements listed. WLS Lighting Systems is not responsible if a pole order has a lower EPA rating than the indicated wind-loading zone where the pole is located.

    CAUTION:This guarantee does not apply if the pole/bracket/fixture combination is used to support any other items such as ags, pennants, or signs, which would add stress to the pole. WLS Lighting Systems cannot accept responsibility for harm or damage caused in these situations.

     


     

    wls_rts_pole_Page_1

    Related Projects

    This is a unique website which will require a more modern browser to work! Please upgrade today!